www.commscope.com
User Guide 860633028
June 2018
Page 25 of 30
© 2018 CommScope, Inc. All Rights Reserved
Rebooting Using the RESET Button
After the imVision Controller X has been running for at least several minutes, pushing the RESET button will cause the
imVision Controller X to reboot. To cause a reboot in this case, push and hold the RESET button for 5 seconds before
releasing it. To indicate the reboot, the STATUS LED will turn red after a slight delay.
Resetting to Factory Defaults Using the RESET Button
The RESET button can be used to erase all information in the imVision Controller X and reset all configuration, network and
security settings to factory defaults. The installed firmware version is not affected by this operation.
Please use the following procedure:
1. After the imVision Controller X has been running for at least several minutes, reboot the imVision Controller X by
pressing the RESET button for 5 seconds before releasing it
2. Wait at the STATUS LED cycles through red, green, then blue to indicate the boot sequence.
3. Within 2 minutes after the STATUS LED turns blue, push and hold the RESET button
4. Wait until the STATUS LED turn red before releasing the RESET button
To Next Page
Loading...