INS_NetWave_REV– 06/10/13 PAGE 34
INSTALLATION AND OPERATION MANUAL NETWAvE
TECH SUPPORT: 1.888.678.9427
10.8 Backup/Flash Firmware
The System » Backup/Flash Firmware page lets you perform backup and restore, or flash a new
firmware.
10.8.1 Backup/Restore
Download backup Generate archive: Downloads a tar archive of the current configuration files.
Note: The backup archive file should be stored in a safe place because it contains the wireless
password in clear text.
Reset to defaults Perform reset: Resets the firmware to its initial state.
Restore backup Upload archive: Lets you upload a previously generated backup archive to restore
configuration files.
10.8.2 Flash new firmware
You can upload a new firmware to replace the currently running firmware.
Keep settings Retains the current configuration.
Firmware Shows the current version of the firmware and allows you to upload a new firmware.
10.9 Reboot
Perform reboot Reboots the operating system of your device. This is similar to the power-off and
power-on cycle. The system configuration remains the same. Any changes that are not
applied are lost.
To Next Page
Loading...