22
TABLE 1
TYPICAL LUBRICANT SPECIFICATIONS
Non-Detergent Turbine or Hydraulic Oil or Synthetic PAO (polyalphaolefin) Lubricant
Viscosity at 100°F................................................................................................160-200 SSU
Viscosity at 0°F .........................................................................................11,000 SSU or Less
Minimum Viscosity Index......................................................................................................90
Pour Point, °F..20° lower than lowest expected starting temperature Minimum Flash Point, °F..400
Rust Inhibitor....SSTM, D665 (latest) No rust after 24 hours sea water Oxidation Inhibitor....ASTM,
D943 (latest) Neutral No. 2.0 or less after 1000 hours
Anti-Foam Additive...............ASTM, D892 (latest) 3 cycles stability nil
To Next Page
Loading...
