K06307 | v. 12/07/2016 | Ref. quality process 002/03 | ORIGINAL INSTRUCTIONS
11
*NOTE: Changing grind settings must be done when the grinder is on and burrs are in motion.
Not doing this suposes that the burrs will gunk up and cleaning will be required.
* It is recommended that the motor be running when adjusting to ner grind setting.
This helps to avoid jamming the burrs, which can occur when coffee beans are in the
grind chamber, and the grind regulator is adjusted towards ne.
8.3.2. Stepped grind adjustment (optional)
In the stepped adjustment versions, the positions on the grind regulator are limited
by “steps” that are dened by the hole and pin points (Fig. 6).
To Next Page
Loading...
