Compak K-5 - Safety Measures

Fig. 10
Unthreading
direction
Threading
Threading
direction
direction
cavity, the burr holders and the upper and lower burrs. Check
the condition of the burrs and change them if necessary. Put the
upper burr holder back in place and turn counter-clockwise until
the burrs touch. Turn counter-clockwise until the “Espresso area”
screw is at the front of the grinder, between the  rst grinding point
and the “Espresso area” stop.
Tighten the “Espresso area” screw and replace the screw cover (7).
Reassemble the hopper (2), thread the hopper safety screw with
help of a flat-head screwdriver and adjust the setting roller (5) by
hand. Fig. 1. Remember to always check the grinding conditions
after this operation, following the instructions in point 7.1.
To access to grinding chamber, remove the position indicator (7)
and unthread the block screw, then remove the upper burr holder
the grind regulator (see the direction in Fig 10). To replace it,
thread the burr holder (Fig 10) until it reaches the grinding point
(this is when the burrs touch and a metallic noise can be heard).
Turn the block screw and the position indicator (7) is put back
on.
NOTE: The manufacturer cannot accept responsibility for any
damage caused by improper use of the machine or failure to
respect the safety measures indicated above.
Users are asked to pay careful attention to the following
indications:
• The coffee grinder should only be used for grinding coffee
beans.
• Do not use the machine to grind other types of foods such
as nuts, dried fruits or to  ne-grind granulated foods such as
sugar, etc.
• Do not allow minors or disabled people to use the machine.
• Any other use of the machine will be considered improper
and dangerous.
• Do not allow liquids to come into contact with the internal or
external surfaces of the machine at any time, except for those
parts that have been expressly referred to in the “CLEANING”
section. If, for any reason, this should occur, immediately
disconnect the machine from the power supply and dry all
surfaces carefully. Should it be necessary to access the internal
parts of the machine, where the electrical components are
located, take the machine to your local technical service.
• In the event of any broken components or intervention, we
recommend that you contact your local technical service, who
will repair or replace the part, guaranteeing the maintenance of
the safety standards.
• Replacement of the main power cable of any Compak grinder
can only be carried by Compak or an authorized supplier.
11
Safety measures
i
!