Compak K3 TOUCH - Bean Hopper Cleaning; Grind Chamber Cleaning

K01070 | v. 25/03/2014 | Ref. quality process 002/03 | ORIGINAL INSTRUCTIONS
15

In order to properly clean the bean hopper ( ),rstemptyoutallremainingbeans
and fragments.
Toremovethehopper,rstclosethebeantrap(
), and then loosen the hopper lock
screw (
) and lift the hopper straight up.
Clean the hopper (
) with a moist soft cloth or with a small amount of water and
soap to eliminate any oily residue from the beans.
Replace the bean hopper (
) following the same steps as the removal process, but
in reverse.

It is recommended that the grind chamber be cleaned monthly with a cleaner as
recommended by Compak. This process will eliminate smelly residues from the
coffee remains, which can negatively affect the quality of the brewed coffee.
The steps to follow are:
In order to properly clean the bean hopper (
),rstemptyoutallremainingbeans
and fragments.
• Close the bean trap on the hopper (
) and grind out the remaining coffee in the
grind chamber.
• Remove any remaining coffee beans from the bean hopper (
).
• Pour the recommended grinder cleaning product into the bean hopper (
) and
open the bean trap (
), allowing the cleaning product to pass into the grind
chamber.
• Grind the cleaning product at a medium course grind setting until the recommended
amount is passed through the system and nothing remains in the grind chamber.
• Clean the hopper (
)andrellwithcoffeebeans.
• Discardtherst2-3dosesofcoffeetoassurethattheresidualcleaningproduct
is removed from the grind chamber and set the grind regulator to the desired
setting (
).
Following these steps will ensure that the grinder is clean and ready for use.
We do not recommend the taking apart of the grind assembly unless changing burrs,
or removing a blockage/obstruction in the grind chamber. Removal of the grind
assemblyshouldbeperformedbyaqualiedservicetechnician.