Compaq 5000 Series - Locating and Removing the DVD-RAM Drive; Identifying the DVD-RAM Drive; Disconnecting Drive Cables

R
EPLACING THE
1394 C
ARD
11
2. The 1394 card rear connector(s) 1 must be inserted
properly into the expansion card rear connector slot 2 to
ensure the card will seat properly into the PCI slot on the
system board (see Figure 5-2).
Note: Carefully insert the rear connector(s) on the 1394 card inside the
expansion card rear connector slot on the chassis.
Figure 5-2
Ensure that the card is
properly positioned into the
rear connector slot on the
chassis.
Tip