Reference Guide
F-1
Writer: Dianne Fielden Saved by: ACastle Saved date: 07/24/97 4:37 PM
Pages: 2 Words: 402 Template: c:\template\commercial\commapp.dot
File Name Appf.doc Part Number 308336-001
appendix
F
P
OWER
C
ORD
S
ET
R
EQUIREMENTS
The voltage select switch feature on the computer permits it to
operate from any line voltage between 100-120 or 220-240
volts AC.
The power cord set received with the computer meets the
requirements for use in the country where you purchased the
equipment.
Power cord sets for use in other countries must meet the
requirements of the country where you use the computer. For
more information on power cord set requirements, contact your
authorized Compaq dealer, reseller or service provider.
General Requirements
The requirements listed below are applicable to all countries:
1. The length of the power cord set must be at least 6.00 feet
(1.8 m) and a maximum of 9.75 feet (3.0 m).
2. All power cord sets must be approved by an acceptable
accredited agency responsible for evaluation in the country
where the power cord set will be used.
3. The power cord set must have a minimum current capacity
of 10A and a nominal voltage rating of 125 or 250 volts
AC, as required by each country’s power system.
4. The appliance coupler must meet the mechanical
configuration of an EN 60 320/IEC 320 Standard Sheet
C13 connector, for mating with appliance inlet on the
Switch Box.
To Next Page
Loading...
