I-2
System Board Jumpers and Switches
Writer: Your Name Saved by: Holly Jahangiri Saved date: 07/24/97 4:36 PM
Pages: 3 Words: 356 Template: c:\template\commapp.dot
File Name Appi.doc Part Number 308336-001
Switch SW1 Processor Speed
S2 S3 S4 S5 S6 Processor Speed
On On Off On Off 166-MHz
Off On Off On Off 200-MHz
System Board Jumpers
This section provides information for setting DIP switches to
enable/disable passwords and setting jumpers to clear the
configuration (CMOS). Setting the system board jumpers are
part of the reconfiguration process, along with running the
Computer Setup utility. If the system configuration is incorrect,
your computer may not work properly and you may receive
error messages on the screen.
Switch SW1 Password
S1 Action
On Password disabled
Off Password enabled
✎
For information on using the position 1 switch to disable
a password, see Chapter 2, “Using Intelligent
Manageability.”
To change DIP switch and jumper settings, you must
remove the computer cover. For procedures on removing
the computer cover, refer to Chapter 4, “Upgrading the
Desktop Computer.”
!
CAUTION:
To reduce the risk of personal injury from hot surfaces,
allow the internal system components to cool before touching.
WARNING:
Be sure to turn off the computer before changing a
jumper setting or damage to the system board can result.
To Next Page
Loading...
