Reference Guide
I-3
Writer: Your Name Saved by: Holly Jahangiri Saved date: 07/24/97 4:36 PM
Pages: 3 Words: 356 Template: c:\template\commapp.dot
File Name Appi.doc Part Number 308336-001
System Board Jumpers
Clearing Configuration
The computer's configuration (CMOS) may occasionally be
corrupted. If this happens, it is necessary to clear the CMOS
memory.
To clear and reset the configuration perform the following
procedure:
1. Prepare the computer for disassembly.
2. Remove the system unit cover.
3. Remove the P14 jumper from pins 1 and 2 for 60 seconds;
then, replace the jumper.
4. Replace the system cover.
5. Turn the computer on.
6. Run the Computer Setup utility to reconfigure the system.
When the jumper is removed, both the power-on password and
setup password are cleared because they are stored in the
configuration memory. You will need to reestablish the
passwords through Computer Setup.
To Next Page
Loading...
