CD and DVD Software
Software Guide 1–17
To erase DirectCD formatting from a rewritable medium so the
medium can be used with Easy CD Creator or CD Copier:
1. Insert the medium into an optical drive. (If you are prompted
to install UDF Reader, refer to “Responding to the UDF
Prompt” earlier in this section.)
2. Access the Easy CD Creator Basic Eraser:
❏
In Windows 2000 Professional, select Start > Programs >
Easy CD Creator Basic > CD-RW Eraser.
❏
In Windows XP Home or Windows XP Professional,
select Start > All Programs > Easy CD Creator Basic >
CD-RW Eraser.
3. Select the Erase button.
4. Select the OK button.
Selecting Easy CD Creator Settings
To use DirectCD, Easy CD Creator, or CD Copier, the settings
shown in the following table must be selected. These settings are
compatible; for example, the settings for DirectCD do not conflict
with the settings for CD Copier.
The Easy CD Creator software installs with all of these settings
selected. Before beginning any copying procedure, you may want
to confirm that these settings have not been changed.
Application Required Settings
DirectCD Enable Auto Insert Notification
Easy CD Creator Disable Disk-at-Once
and
Enable Track-at-Once
CD Copier Disable Disk-at-Once
To Next Page
Loading...
