Security
Software Guide 3–9
3. To open Computer Setup, turn on (do not restart) the
notebook. Press
F10
while the F10 = ROM Based Setup
message is displayed in the lower left of the screen.
❏
To change the language, press
F2.
❏
For navigation instructions, press
F1.
4. Use the arrow keys to select the Security menu > DriveLock
passwords, then press
enter.
5. Select the location of the hard drive, then press
F10.
6. Toggle the Protection field to Enable.
7. Read the warning. To continue, press
F10.
8. Type your user password in the New Password and Verify
New Password fields, then press
F10.
9. Type your master password in the New Password and Verify
New Password fields, then press
F10.
10. To confirm DriveLock protection on the drive you have
selected, type DriveLock in the confirmation field, then
press
F10.
11. To save your DriveLock settings, select File > Save Changes
and Exit, then follow the instructions on the screen.
Your preferences are set as you exit Computer Setup and are
in effect when the notebook restarts.
Accessing a Protected Hard Drive
1. Be sure that the drive is inserted into the notebook (not an
optional port replicator).
2. When prompted for a DriveLock password, type your user
or master password, using the same keys you used to set the
password, then press
enter.
After 2 attempts to enter the
password correctly, you must restart the notebook and
try again.
To Next Page
Loading...
