EasyManua.ls Logo

Compaq Presario 5700 Series - Page 51

Compaq Presario 5700 Series
187 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Diskette drive cannot write to a
diskette
1. Diskette is not formatted. Format the diskette.
2. Diskette is write-protected. Either use another
diskette that is not write-protected, or disable the
write protection on the diskette.
3. Writing to the wrong drive. Check the drive letter
in your path statement.
4. Not enough space is left on the diskette. Use
another diskette to write the information.
Diskette drive cannot read a diskette 1. Diskette is not formatted. Format the diskette.
2. Using the wrong diskette type for the drive type.
Use a diskette that is compatible with the drive.
3. Reading the wrong drive. Check the drive letter in
your path statement.
4. Diskette drive has been disabled by Setup. Run
Setup and enable the diskette drive.
Top
Solutions for Monitor Problems
Problem Possible Solution
Characters are dim The brightness control is not set properly. Adjust the
brightness control.
Screen is blank 1. A screen-blanking (energy-saving) utility could be
installed. Press any key. If the display reappears,
you have a screen-blanking utility installed.
2. The brightness needs adjusting. Adjust the
brightness control.
3. Screen saver has been initiated. Press any key or
move the mouse to light the screen.
4. System is in Sleep mode. Press the Sleep button
to wake up.
Compaq.com - Compaq Presario Maintenance and Service Guide - 5700 Series
http://www.compaq.com/athome/support/msgs/5700/trbwod.html (3 of 8) [1/10/2002 11:55:35 AM]

Related product manuals