Need help?Do you have a question about the Compaq UPS R3000 XR and is the answer not in the manual?
General| Power Capacity | 3000 VA / 2700 W |
|---|---|
| Rack Size | 2U |
| Battery Type | Sealed Lead-Acid (SLA) |
| Frequency | 50/60 Hz |
| Battery Recharge Time | 3 hours to 90% |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -15°C to 45°C |
| Humidity | 0-95% non-condensing |
| Communication Ports | RS-232, USB |
| Input Voltage | 200-240 VAC |
| Output Voltage | 200-240 VAC |
| Interface | RS-232, USB |
| Transfer Time | 4 ms typical |
| Dimensions | 85 x 440 x 660 mm |
| Form Factor | Rack/Tower Convertible |
Explains icons used in the guide for warnings and notes.
Provides important safety and repair guidelines for authorized technicians.
Lists sources for further assistance, documentation, and software.
Provides telephone numbers for resellers and technical support.
Outlines critical safety warnings regarding hazardous voltage and energy circuits.
Details icons indicating electrical shock, hot surfaces, and weight hazards.
Covers technician safety, rack mounting, and product weight handling guidelines.
Specifies approved cables for connecting the UPS communication port.
Emphasizes safety when handling batteries and Extended Runtime Modules.
Explains the REPO feature and its safety requirements for system shutdown.
Visual breakdown of the main UPS unit components with reference numbers.
Visual breakdown of the Extended Runtime Module components.
Reviews safety warnings and lists replaceable parts for the UPS.
Lists necessary tools and guides users on identifying UPS components.
Describes the UPS front panel controls and status LED indicators.
Identifies the various ports and connectors on the UPS rear panel.
Explains the four operating modes: Standby, Operate, Configure, and Auto-Bypass.
Details procedures for safely powering down the UPS and emergency shutdown.
Step-by-step guide for replacing the main UPS battery pack.
Instructions for the proper environmental disposal of used UPS batteries.
Procedure for removing and installing the UPS electronics module.
Steps for swapping out option or communication boards.
Instructions for removing and installing the entire UPS unit.
Covers ERM overview and procedures for replacing ERM battery packs.
Steps for removing and installing an entire ERM unit.
Guide to diagnosing and resolving problems during UPS startup.
Guide to diagnosing and resolving problems after the UPS has started.
Details dimensions and weight of the UPS unit.
Specifies voltage, frequency, and power cord details for different models.
Lists output voltage, power ratings, and receptacle types per model.
Covers overcurrent protection, battery type, voltage, charging, and runtime.
Specifies operating temperature, humidity, altitude, and noise levels.
To Next Page
