. . . . . . . . . . . . . . . . . . . . . . . . .
Appendix B
Power Cord Set Requirements B-1
Part Number 264154-001 - - Writer: Marianne Silvetti - Saved by Marianne Silvetti - Saved date: 05/15/96 10:26 AM
File Name T:\docs\codename\partnumber\APPB.DOC
Power Cord Set Requirements
The monitor power supply is provided with Automatic Line
Switching (ALS). This feature allows the monitor to operate on
input voltages between 100-120V or 220-240V.
The power cord set (flexible cord or wall plug) received with the
monitor meets the requirements for use in the country where you
purchased the equipment.
Power cord sets must meet the requirements of the country where
you use the monitor. For more information on power cord set
requirements, contact your Compaq authorized dealer, reseller or
service provider.
General Requirements
The requirements listed below are applicable to all countries:
1. The length of the power cord set must be at least 5.00 feet
(1.5 m) and a maximum of 9.75 feet (3.0 m).
2. All power cord sets must be approved by an acceptable
accredited agency responsible for evaluation in the country
where the power cord set will be used.
3. The power cord set must have a minimum current capacity of
10A and a nominal voltage rating of 125 or 250 volts AC, as
required by each country’s power system.
4. The appliance coupler must meet the mechanical configuration
of an EN 60 320/IEC 320 Standard Sheet C13 connector, for
mating with appliance inlet on the rear of the unit.
To Next Page
Loading...
Need help?
General
