. . . . . . . . . . . . . . . . . . . . . . . . .
1-2 Introduction
Part Number 264154-002 - - Writer: Marianne Silvetti - Saved by Marianne Silvetti
Saved date: 05/15/96 9:52 AM - File Name T:\docs\codename\partnumber\CH1.DOC
■
Energy Saver feature, when activated, results in a power savings
of greater than 90 percent
■ Compliant with the following regulated specifications:
- EPA Energy Star
- European Union CE Directives
- Swedish MPR II 1990
- Swedish TCO 1995 on certain models
Installing the Monitor
To install the monitor, ensure that the power to the monitor,
computer system, and other attached devices is turned off, then
follow these steps:
1. Place the monitor in a convenient, well-ventilated location near
your computer.
2. Connect the monitor signal cable ➊ to the 15-pin connector on
the rear panel of the computer and tighten the screws.
IMPORTANT: Be sure the signal cable aligns with the 15-pin
connector. Do not force the cable onto the connector or you may
damage the signal cable.
To Next Page
Loading...
