Competition Electronics Pocket Pro II - PAR Time Setting; Start Delay Configuration; Instant (No Delay)

User Manual / Operating Instructions
5
Setting the PAR Time (second beep)
The par time setting (also known as the “second beep”) comes congured from the
factory for 0 seconds. When the par time is set to 0, the timer will beep only once, at
the start of a timing cycle. Setting the par time to other than 0 will give you a beep
at the start, and the end of the par time period. Par time is adjustable from 0 to 199.9
seconds. Hold the SET UP or SET DOWN button to increase the speed at which the
digits increment for large par times. Press the SET UP and SET DOWN buttons simulta-
neously to reset the Par Time to zero.
Setting the Start Delay
The start delay is completely congurable. If enabled, it can generate a xed delay
or random delays between .5 seconds and 9.9 seconds. The timer is set to a factory
default delay time between 1 and 4 seconds.
Instant (No Delay)
Using the MENU UP/DOWN buttons, advance to the “START DELAY TYPE” screen. Use
the SET UP or SET DOWN button to select “ INSTANT.” The timer will start instantly
when you press the start button.