Competition Electronics Pocket Pro II - RPM Mode Operation; Single Time Only Mode

User Manual / Operating Instructions
8
“RPM” Mode
When the “Rounds per Minute” main display is
selected, the Pocket Pro II no longer displays shot
times, but now will display rounds per minute. To
use this mode, press the START button. After the
beep, re shots; the timer will display the rounds
per minute based on the number of shots and
the time between the rst shot and the last. Shots
recorded more than 199.99 seconds after the start beep will render readings invalid
until START is pressed again. The normal shot dead time setting is overridden when
in RPM mode and set to a xed value of 0.032 seconds. This allows the Pocket Pro II to
detect shots at rates of up to 1800 RPM.
(NOTE: Please see Accuracy on page 10)
Single Time Only
When the “Single Time Only” main display is
selected, the current shot time appears on the main
display and is sized to ll up the screen. Pressing
either the SET UP or SET DOWN button will jump
directly to the shot review screen. Pressing the
MENU UP will return to the main display screen.
SPL 0.1 1
1st 0 .71
DELAY RNDM
JAN/01/13
SHOT #30
458
18.65