07
EN
BATTERY INSERTION
Open the battery compartment cover and insert the battery, with the label pointing upwards so that the +
and - terminals are opposite the device’s contacts. Then replace the cover. If the device is not going to be
used for over 3 months, ensure that the battery is fully charged. If the device is not going to be used for over
6 months, ensure that the battery is fully charged and remove it from the stimulator. Switch the stimulator off
before removing the battery.
CONNECTIONS
CHARGER CONNECTION
Remove all stimulation cables from the stimulator before recharging it. Connect the charger to a wall socket
and connect the stimulator by sliding the red cover to the right to reveal the charger connector. It is strongly
recommended to fully charge the battery before its first use to improve its performance and life span.
CONNECTING THE CABLES
The cables of the stimulator connect to the 4 sockets at the front of the device.
COMPEX
COMPEX
To Next Page
Loading...
