OPERATION
DURING THE STIMULATION SESSION
A. ADJUSTING STIMULATION ENERGIES
When you start a program, you will be prompted to increase the stimulation
energies. This is critical to the success of any program. To find out what energy level
needs to be reached for each program, refer to the applications menu.
Program time
in minutes and
seconds
The animated
rising convection
symbol represents
the warming-up
sequence
Session
progression
scale
See Program
Progession for
more details
A
B
C D E
A Press the On/Off button to place the unit in Pause mode.
B/C/D/E The Compex Edge "bleeps" and the symbols of the four channels
flash, changing from + to 000: the four channels are at 000 energy. You
must increase the stimulation energy so that the stimulation can start.
To do this, press the + buttons for the relevant channels until the
desired setting is reached. If you want to increase the energy level
of all four channels simultaneously, press the "i" button, located
below the On/Off button. Press the "i" button twice to increase the
levels in the first 3 channels, and 3 times to increase the levels in the first
2 channels. When you press the "i" button, the associated channels are
highlighted in white on a black background.
C Press the Channel 2 +/- button to select or not the warming-up sequence
(warming-up sequence is activated when the small animated rising convention
symbols above the radiator are visible).
D Use the Channel 3 +/- button to choose the program difficulty level.
E Use the Channel 4 +/- button to confirm your choices and launch the program.
To Next Page
Loading...
Need help?
General
