159
EN
Compex Fit - User Manual
Battery level
The battery icon on the top right of the screen indicates the level of charge in the
battery. The battery icon flashes when the battery is totally flat. It is no longer possible
to use the device. Recharge it immediately.
Recharging
Remove all stimulation cables from the stimulator before recharging it. Plug the charger
into a socket and connect the stimulator by sliding the red cover to the right to free the
charger connector.
The charge menu illustrated below appears automatically.
The duration of the charging operation is shown on the screen (a complete charge
may take 10 hours). The battery icon is animated while the battery is recharging.
When fully charged, the icon will be full and the total time taken to recharge the
battery will flash on the screen. Simply disconnect the charger: the Compex will turn off
automatically.
Problems and solutions
Electrode fault
The Compex "bleeps" and alternatively displays the symbol of a pair of electrodes and
an arrow pointing to the channel where a problem has been detected. In the example
above, the stimulator has detected an error in channel 1.
• Check that electrodes are connected to this channel.
• Check whether the electrodes are old, worn, and/or the contact is poor: try using new
electrodes.
• Try using the stimulation cable on a different channel. If the cable is still showing a
fault, replace it (www.cefarcompexstore.com).
To Next Page
Loading...
Need help?
General
