15
SETUP
Remove the 2 devices and accessories from the box. The accessories include electrodes, lead wires and a USB cable. The USB cable should be used
to charge both units.
1. There are two devices included. The device marked “1” on its side is the master device, and the device marked “2” is the affiliation device. The
master device and the affiliation device are paired as received. Therefore, after turning on the devices, you can use them directly out of the box.
Note: If the devices unpair, you can pair the mother device with the affiliation device manually. Use a pin to press the PAIR (RESET) hole on the back
of the devices. Press and release the reset hole of the affiliation device first (beeping twice (0.5s per beeping) and the LED lights keep flashing),
meaning the affiliation device is ready for pairing; then press and release the reset hole of the mother device (beeping and flashing once, 0.5s per
beeping/flashing) to send the pairing signal to the affiliation device. When the pairing is successful, the affiliation device will beep once (0.5s per
beeping) and its LED lights becomes steadily on. Pressing the reset hole for more than 2 seconds could unpair the affiliation device, indicated by the
flashing/beeping twice (0.2s per beeping/flashing).
2. Intensity levels +/- can only be increased or decreased via puck 1 (master device).
3. Alternatively, the phone appliacation can automatically pair with the master device and operate it via Bluetooth. Simultaneously, the master device
controls the affiliation device via the radio frequency. If using one device make sure it is the master device which is marked “1” on its side. Note:
Cannot independently use puck #2
PIN HOLE