EasyManua.ls Logo

Compex Runner - Mi-SCAN Function Explained; Mi-TENS Function Explained; Mi-RANGE Function Explained

Compex Runner
181 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
EN
END OF A PROGRAMME
At the end of a session, the following screen is displayed. To stop the stimulator, press the on/o button.
N.B. Depending on the programme, usage statistics may be displayed (see previous chapter “Programme progression”).
BATTERY LEVEL AND CHARGING
Battery performance depends on the programme and the stimulation intensity applied. It is strongly recommended to fully
charge the battery before its rst use to improve its performance and life span. Always use the charger supplied by Compex to
recharge the battery.
If the device is not going to be used for over 3 months, ensure that the battery is fully charged. If the device is not going to be
used for over 6 months, ensure that the battery is fully charged and remove it from the stimulator. Switch the stimulator o
before removing the battery.
BATTERY LEVEL
The battery charge level is shown by a battery icon in the bottom left of the screen. The battery icon ashes when the battery
is completely at. The device can then no longer be used. Recharge it immediately.

Table of Contents

Other manuals for Compex Runner

Related product manuals