Compex Sport - Monitoring and Adjusting During Operation

31
ENGLISH
VII. Operating Instructions
10a The “Compex® Sport”
makes a “bleeping”
sound and the “+”
symbols of the 4
channels flash: when
this occurs, you should
increase the current
intensity.
10b
To return to preceding
screen, press the
“On/Off” switch.
10c
Remaining time (in
minutes and seconds)
before the end of the
session.
10d Channels 1, 2, 3, 4 are set to 0 milliampere: this means that
you have not yet adjusted the electric current levels.
Figure 10
During Operation
Figure 11
11a
“Bleep” during the
session: The operating
current is a key element
in the effectiveness of
treatment. During a
session, the stimulator
automatically requests
an increase in the
current level by flashing the “+” and “bleeping”. If you are not
ready to progress further, this message may be disregarded.
11b
“STOP” function: You can interrupt the program at any time
by pressing the “On/Off” switch (“STOP”). If you wish to restart
the session, simply press one of the “+” keys. Caution: the
program restarts at 80% of the currents set before the “STOP”.
SpUS Manuel EN:SpUS Manuel EN 31/01/08 15:59 Page 31