iii
EEC Regulations
Hereby Sferal WWT declares that this product is in compliance with the
essential requirements and other relevant provisions of EU Directives
2006/95/EC and 2004/108/EC. Sferal WWT cannot accept responsibility for
any failure to satisfy the protection requirements resulting from a non
recommended modification of the product, including the fitting of non Sferal
WWT-Compuprint option cards.
This product has been tested and found comply with the limits for Class A
Information Technology Equipment according to European standard EN55022.
The limits for Class A equipment derived for commercial and industrial
environments to provide reasonable protection against interference with
licensed communication devices.
This is a Class A product. In a domestic environment this product may cause
radio interference in which case the user may require to take adequate
measures.
Properly shielded and grounded cables and connectors must be used in order to
reduce the potential for causing interference to radio and TV communications
and to other electrical equipment . Sferal WWT cannot accept responsibility for
any interference caused by using other than recommended cables and
connectors.
To Next Page
Loading...
