MNC-0000-015 10 of 10 Revision F
Operation Addendum, Block Upconverter
upconverter fault when the fault condition is corrected, by enabling
the Auto Clear Upconverter Fault feature.
Factory Default Settings:
The factory default settings of the upconverter and reference
frequency are listed below in Table 1. These settings have been
chosen to allow HPA functionality with the simplest setup.
Table 1, Factory Default Configuration
Fault/Feature Description Default State Fault/Event Log Abbreviation
Upconverter Fault Enabled
(On)
UC Fault
Auto-Clear Upconverter Fault Enabled
(On)
N/A
External Reference Present Disabled
(Off)
Ext Ref Pres
External Reference Lock Disabled
(Off)
Ext Ref Lock
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.
To Previous Page
Loading...
