29
COMUNELLO ®Copyright 2019 - All rights reserved
ENGLISH
LEDs to light simultaneously followed immediately by the control unit switching
off.
9 DIAGNOSTICS
9.1 Photocell Test
The control unit is prearranged for connection of safety devices in compliance
with standard EN 12453 point 5.1.1.6. At each operating cycle a functional test
of the connected photocell is performed. In the case of an open circuit and/or
malfunctioning of the photocell, the control unit does not enable movement of the
gate and visually signals the test failed condition by causing all the indicator LEDs
to blink simultaneously. As soon as correct operation of the photocell is restored,
the control unit is ready for normal use. This operating mode guarantees failure
mode monitoring in compliance with EN 954-1 Category 2.
9.2 Commands input test:
In correspondence with each low voltage command input, the control unit is
equipped with an indicator LED so that the status of the input can be checked
at a glance.
Operating logic: LED on input closed, LED off input open.
10 WARRANTY
a) In business relationships or in case of products sold for professional
use, this warranty is limited to the repair or replacement of product parts
that FRATELLI COMUNELLO SPA acknowledges as defective, through
equivalent re-manufactured Products (the “Conventional Warranty”); the
warranty does not include the costs necessary for repairing or replacing
the material (e.g. labour costs, rental of equipment etc).
b) The provisions contained in articles 1490 to 1495 of the Italian Civil
Code shall not apply.
c) FRATELLI COMUNELLO SPA warrants the proper operation of the
products within the limits indicated in a) above. Unless otherwise
agreed, the validity of the Conventional Warranty is 24 (twenty-four)
months from the production date, which can be found on the products.
The Warranty shall be effective and binding on COMUNELLO only if the
product has been correctly installed and maintained in accordance with
the installation and safety rules set out in the documentation provided
by COMUNELLO or otherwise available on the website http://www.
comunello.com/corporate/ general_conditions_sales/
d) The warranty does not cover: failures or damage caused by transport;
failures or damage caused by defects in the electrical system of the
buyer and/or by carelessness, negligence, inadequate or abnormal
use of such system; failure or damage due to tampering carried out
by unauthorized personnel or due to incorrect use / installation (in this
regard, system maintenance at least every six months is recommended)
or the use of non-original spare parts; defects caused by chemical
agents and/or atmospheric phenomena. The warranty does not cover
the cost of consumables; in any event, COMUNELLO shall be entitled
to a consideration for the work performed at the Customer, where such
work proves useless as the warranty did not apply or because the
customer had used the Comunello product in a negligent, reckless
or incompetent manner, such that the proper use of the product could
have avoided the work.
e) Implementation terms: unless otherwise agreed, the right to the
Conventional Warranty is exercised by showing a copy of the purchase
document (invoice) to COMUNELLO. Any defect must be notied to
COMUNELLO within the time limit of thirty (30) days from detection of
the defect.
The action must be exercised within the limitation period of 6 (six)
months from detection of the defect. The Product parts for which the
Customer requests application of the Conventional Warranty must be
returned by the Customer to FRATELLI COMUNELLO SPA, Via Cassola
64, 36027 Rosà (VI) Italy.
f) The Customer cannot claim compensation for indirect damage, loss of
prots, loss of production and in any case it cannot claim compensation
for an amount that exceeds the value of the supplied components or
products. All transport costs for Products that have been repaired or to
be repaired, although covered by the Conventional Warranty, shall be
charged to the Customer.
g) No external work carried out by Comunello technical staff is covered
by the Conventional Warranty.
h) Specic amendments to the Conventional Warranty conditions
described herein can be dened by the parties in their commercial
contracts.
i) The Court of Vicenza (Italy) shall be the place of jurisdiction for any
dispute which will be settled according to the Italian laws.