Conceptronic C54BRS4A User Manual
36
IP Address If you have selected the Static PPPoE option, type in the global IP
address used for your WAN interface. Your ISP should provide this IP
address to you.
MAC Address To use the Clone MAC Address feature, enter a MAC address in this
field and then click the Clone MAC Address button.
Primary DNS Enter the Primary DNS Address. This information should be provided to
you by your Internet Service Provider.
Maximum Idle Time A value of 0 means that the PPP connection will remain connected. If
your network account is billed according to the amount of time the
Router is actually connected to the Internet, enter an appropriate Idle
Time value (in minutes). This will disconnect the Router after the
WAN connection has been idle for the amount of time specified.
MTU The Maximum Transmission Unit size may be changed if you want to
optimize efficiency for uploading data through the WAN interface.
The default setting (1500 bytes) should be suitable for most users.
Some user may want to adjust the setting to optimize performance for
wireless traffic or when low latency is desired (such as with Internet
gaming). It is highly recommended that the user research how
adjusting the MTU may affect network traffic for better or worse.
Connect mode select Select the desired option: Always on, Manual, or Connect on demand.
Most users will want to choose the default connection setting, Always
on.
To Next Page
