Mechanical Key Cutting Machine CONDOR XC-002
TABLE OF CONTENTS
1）SAFETY PRECAUTIONS AND WARNINGS-----------------------------------------01
2）GENERAL INFORMATION-------------------------------------------02
2.1BRIEF INTRODUCTION---------------------------------------------------02
2.2CHARACTERISTICS------------------------------------------------------02
3）PRODUCT PACKAGING CHECKLIST----------------------------------------------03
4）OVERVIEW
4.1 SCHEMATIC------------------------------------------------------06
4.2 SPECIFICATIONS AND PARAMETERS-----------------------------------------07
4.3 MAIN COMPONENTS AND FUNCTION INSTRUCTION----------------------08
5）MACHINE INSTALLATION AND PREPARATION
5.1 INSTALLING THE MAIN HANDLE--------------------------------------------15
5.2 INSTALLING THE SUB HANDLE---------------------------------------------16
5.3 INSTALLING AND REMOVING PROBE/CUTTER---------------------------17
5.4 CLAMP INSTALLATION---------------------------------------------------18
5.5 PROBE/CUTTER HEIGHT LEVEL ADJUSTMENT----------------------------19
5.6 ROTATION ADJUSTMENT----------------------------------------------------20
6）OPERATING INSTRUCTIONS
6.1 KEY ALIGNMENT--------------------------------------------------21
6.2 SELECTION RULES OF CLAMP SIDES----------------------------------22
7）MAINTENANCE-----------------------------------------------------23
8）WARRANTY AND AFTER SALESSERVICE-----------------------------------------24
9）APPENDIX--------------------------------------------------------------25
To Next Page