Condor XC-002 User Manual

Mechanical Key Cutting Machine CONDOR XC-002
1．SAFETY PRECAUTIONS AND WARNINGS
To prevent personal injury or machine damage, users should carefully
observe the instructions in this operation manual and adopt following safety
precautions:
 Always operate the machine under a safe condition.
 Place the machine on a horizontal surface, which should be firm
enough to carry.
 Do not explore the machine to the direct sunlight, or place the machine
in any wet, oily, or dusty area.
 Please keep the machine clean and dry, and maintain at least 30cm
distance to the wall for ventilation.
 Please wear the safety glasses that meets ANSI standard.
 Keep clothing, hair, hands, tools, test equipment, etc. away from all
moving parts.
 Do not leave the machine while it is operating, and someone
specifically for monitoring is also required.
 Do not place any object on the machine during running.
 Must connect to the grounded power outlet, please do not use the
power outlet if it is broken, loosen or with substandard power.
 Please unplug the machine during maintenance or it is idle.
 Immediately shut down the machine if any exception occurs. The power
switch locates near the power cord connector, at the lower rear part of
the machine.
 Please place the machine out of the reach of children.
2．GENERAL INFORMATION
2.1 BRIEF INTRODUCTION
1

Condor XC-002 Specifications

General

Brand	Condor
Model	XC-002
Category	Cutter
Language	English