When going into the Enhanced Parameter Mode to make an
analog call, first set the channel to an analog channel.
When going into the Enhanced Parameter Mode to make a
digital private call, first set the channel to a digital, private call
channel
When going into the Enhanced Parameter Mode to make a
digital group call, first set the channel to a digital, group call
channel.
When scanning, the radio will only stop on an active channel. If
the channel is not active at the time the scanning gets to it, the
channel will be skipped. If the repeaters are not busy at the time
of the radio is scanning that frequency, the scanning mode will
never show anything. A better solution would to manually set a
known repeater frequency and put in Monitor Mode.
To Next Page
Loading...