17
Setting the Image Resolution in PIR mode:
Your
HUNTING CAMERA
can be programmed to 3 different image
resolutions: 3 Stars is 8Mp, 2 Stars is 5Mp and 1 Star is 3Mp.
• Slide the switch to the CAM position, LCD display will
show the camera status screen.
• Press the [M] button once within 30 seconds to enter the
programming mode.
• The word PIR will be blinking, press [OK] to confirm the
camera’s operation is PIR detection.
• Press [UP] or [DN] button until the word CAM is blinking.
• Press the [OK] button ONCE to confirm the camera into
CAM mode, the STARTS will be blinking.
• Press the [UP] or [DN] button to select the desired
resolution.
• Press [OK] to save your selection, then current number of
burst shoot will blinking. Press [OK] to enter the burst
shoot setting or press [M] button to exit.
Setting the Image burst shoot in PIR mode:
Your
HUNTING CAMERA
can be programmed to shoot 1-9 pictures
per triggering.
• Slide the switch to the CAM position, LCD display will
show the camera status screen.
• Press the [M] button once within 30 seconds to enter the
programming mode.
• The word PIR will be blinking, press [OK] to confirm the
camera’s operation is PIR detection.
To Next Page
Loading...