Conrad SL1007 - Page 18

18
• Press [UP] or [DN] button until the word CAM is blinking.
• Press [OK] button ONCE to confirm camera into CAM
mode.
• Press [UP] button ONCE to enter burst shoot setting, the
current number of burst shoot will blink.
• Press [OK] then press the [UP] or [DN] button to select
the desired burst mode setting or number of pictures per
triggering.
• Press [OK] to save your selection, then the time out T-O
will blinking. Press [OK] button to enter time out setting
or press [M] button to exit.
Setting the Video Resolution in PIR mode:
Your HUNTING CAMERA can be programmed to 2 different video
resolutions: 2 Stars is HD 720, 1 Star is VGA 640 x 480 pixels.
• Slide the switch to the CAM position, LCD display will
show the camera status screen.
• Press the [M] button once within 30 seconds to enter the
programming mode.
• The word PIR will be blinking, press [OK] to confirm the
camera’s operation is PIR detection.
• Press [UP] or [DN] button until the word VIDEO is blinking.
• Press the [OK] button ONCE to confirm the camera in
VIDEO mode, the STARS will be blinking.
• Press the [UP] or [DN] button to select the desired
resolution.