19
• Press [OK] to save your selection, then current number of
video length will blinking. Press [OK] button to enter
video length setting or press [M] to exit.
Setting the Video length in PIR mode:
Your
HUNTING CAMERA
can be programmed
to record 5-300
seconds of video per triggering. The Video mode is only
workable under PIR mode.
• Slide the switch to the CAM position, LCD display will
show the camera status screen.
• Press the [M] button once within 30 seconds to enter the
programming mode.
• The word PIR will be blinking, press [OK] to confirm the
camera’s operation is PIR detection.
• Press [UP] or [DN] button until the word VIDEO is blinking.
• Press the [OK] button ONCE to confirm the camera in
VIDEO mode.
• Press [UP] button ONCE and the video length in seconds
will be blinking.
• Press [UP] or [DN] button to select the desired video
length from 5 to 300 seconds in 5-second increments.
• Press [OK] to save your selection then the time out T-O
will blinking. Press [OK] button to enter time out setting
or press [M] button to exit.
To Next Page
Loading...