20
Setting the Time Out in PIR mode:
Your
HUNTING CAMERA
can be programmed
to set the amount of
time in seconds or minutes the camera will sleep between PIR
triggers
.
• Slide the switch to the CAM position, LCD display will
show the camera status screen.
• Press the [M] button once within 30 seconds to enter the
programming mode.
• The word PIR will be blinking, press [OK] to confirm the
camera’s operation is PIR detection.
• Press [UP] or [DN] button until the word T-O (Time Out) is
blinking.
• Press [OK] button and the MINUTES digits will be blinking.
• Press [UP] or [DN] button to increase or decrease the
time value in minutes from 00 to 10 minutes in 1-minute
increments.
• Press [OK] to save the minute setting and the SECONDS
digits will be blinking.
• Press [UP] or [DN] button to increase or decrease the
time value in seconds from 05 to 55 seconds in 5-second
increments.
• Press [OK] to save the second setting.
• You’ll then see the word T (Time) blinking. Press [OK]
button to enter time setting or press [M] button to exit.
To Next Page
Loading...