Conroy Qseal-extra - Page 8

In compliance with: - EN 60601-1: 2006,
General Reqirements for basic safety and essential performance.
- EN 60601-1-2: 2007,
Collateral standards for Electromagnetic Compatibility.
Electrical safety: During charging Class II.
During use: Internal power supply.
The Qseal-extra is used in the same environment as medical
equipment (hospitals and blood banks).
It must be used by highly qualied personnel.
Manufacturer Conroy Medical AB
according to MDR: Haesthagsvaegen 14A, SE-194 52 Upplands Vaesby, SWEDEN
Guidance and Manufacturer’s Declaration – Electromagnetic Emission
The CS624 Qseal-extra Battery Powered Bench Top Sealer is intended for use in the electromag-
netic environment specied below. The customer or the user of the CS624 Qseal-extra should
assure that it is used in such an environment.
Emission Test Compliance Electromagnetic Environment - Guidance
RF emission
CISPR 11
Group2 The CS624 Qseal-extra must emit electromag-
netic energy in order to perform its intended
function. Nearby electronic equipment may be
aected.
RF emission
CISPR 11
Class A The CS624 Qseal-extra is suitable for use in all
establishments other than domestic and those
directly connected to the public low-voltage
power supply network that supplies buildings
used for domestic purposes.
Harmonic emission
IEC 61000-3-2
Not applicable
Voltage uctuations/
Flicker emissions
IEC 61000-3-3
Not applicable
Table 1:
6
CS624 Qseal-extra Operator´s manual