EasyManua.ls Logo

Consumer Cellular ZMAX 10 - Knowing the Basics; Phone Status ICONS

Consumer Cellular ZMAX 10
77 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28 29
PERSONALIZING
NOTE: Registered fingerprints are listed in the Fingerprint management menu.
You can register up to 5 fingerprints. Tap an existing fingerprint record to
change its name or delete it.
Setting Fingerprint Actions
1. Swipe up on the home screen and tap Settings > Security > Fingerprint >
Fingerprint management.
2. Enter the screen lock pattern, PIN, or password you set.
3. Set the following fingerprint actions.
Wake up and unlock your phone: Allow the phone to wake up and
unlock when you tap the fingerprint sensor.
Simple touch: Bind a registered fingerprint with an app, so you can tap
the fingerprint sensor to open the app when the screen is off or locked.
NOTE: You can also tap the fingerprint sensor with any finger, registered or
not, to take photos or answer calls. Open Settings > Security > Fingerprint >
Take photo / Answer call to turn on or off these features.
KNOWING THE BASICS
PHONE STATUS ICONS
The status bar at the top of the home screen provides phone and service
status icons on the right side. Below are some of the icons you may see.
Indicator What it means
UMTS & HSPA connected
4G LTE connected
Do Not Disturb mode on
Vibration mode
Ringer o
Battery low
Battery full
Battery charging
Wired headset connected
Indicator What it means
No signal
Signal strength
Airplane mode
Connected to a Wi-Fi
network
Wi-Fi in use
Speaker on
Phone microphone o
GPS on
Alarm set

Table of Contents

Related product manuals