IEC 60601-1-1. Everybody who connects additional equipment to the signal
input connector or signal output connector configures a medical system, and is
therefore responsible that the system complies with the requirements of the
valid version of the system standard IEC 60601-1-1. If in doubt, consult our
technical service department or your local distributor.
CAUTION : The device is designed for continuous and is “ordinary” (i.e. not drip or
splash-proof).
CAUTION : Keep the environment clean. Avoid vibration. Keep it far from corrosive
medicine, dust area, high-temperature and humid environment.
CAUTION : Do not operate the unit if it is damp or wet because of condensation or spills.
Avoid using the equipment immediately after moving it from a cold
environment to a warm, humid location.
CAUTION : Do not immerse transducers in liquid. When using solutions, use sterile wipes
to avoid pouring fluids directly on the transducers.
CAUTION
④
Do not use high temperature heating or gas to disinfect the monitor and its
accessories.
CAUTION
④
Turn off the power supply before clean the machine.
CAUTION : The temperature should not exceed 6
0℃
when clean
the belt.
CAUTION : Electromagnetic Interference-Ensure that the environment in which the
fetal monitor is installed is not subject to any sources of strong
electromagnetic interference, such as radio transmitters, mobile telephones,
etc.
CAUTION : The monitor must serviced by proper training and knowledge, practical
personnel. The recommended testing interval is once twice year or under the
leakage current measurement and insulation testing.
To Next Page
Loading...
Need help?
General
