1.3 Safety Precautions
WARNING and CAUTION messages must be observed. To avoid the possibility of injury,
observe the following precautions during the operation of the instrument.
WARNING : EXPLOSION HAZARD-Do not use the in a flammable atmosphere where
concentrations of flammable anesthetics or other materials may occur.
WARNING : SHOCK HAZARD-the power receptacle must be a three-wire grounded
outlet. A hospital grade outlet is required. Never adapt the three-prong
plug from the monitor to fit a two-slot outlet. If the outlet has only two
slots, make sure that it is replaced with a three-slot grounded outlet before
attempting to operate the monitor.
WARNING : SHOCK HAZARD-Do not attempt to connect or disconnect a power cord
with wet hands. Make certain that your hands are clean and dry before
touching a power cord.
WARNING : The monitor should be installed by an authorized and qualified service
engineer.
WARNING : SHOCK HAZARD-Do not remove the top panel covers during operation or
while power is connected.
WARNING : Only connect the device to Contec supplied or recommended accessories, to
avoid the injury of the doctors and patient.
WARNING : Do not switch on device power until all cables have been properly connected
and verified.
WARNING : Don’t touch signal input or output connector and the patient simultaneously.
WARNING : Accessory equipment connected to the analog and digital interfaces must be
certified according to the respective IEC standards (e.g. IEC 950 for data
processing equipment and IEC 60601-1 for medical equipment). Furthermore
all configurations shall comply with the valid version of the system standard
To Next Page
Loading...
Need help?
General
