Edition 03/2022 - ACE – Technical documentation - page 16
SACOME, CONFIDENTIAL Document, it is forbidden to duplicate or communicate this document without previous authorization.
8 DOSES SETTING
Note: On the factory, each machine undergoes a test protocol on which a program has already been
completed, according to the following settings:
1
ST
button = 35 ml
2
nd
Button = 55 ml
3
rd
button = Continuous (not programmable)
It is possible for the user to change the programmed value of the 2 first button:
Put the ground coffee (1 dose or 2 doses), in the suitable filter holder.
Keep B3 button pressed until the display indicate "doS",.
The machine is in “programming doses” mode. The display shows:
The doses programming is allowed within 30". During this time, the 3
rd
button is blinking
Then Press on Dose 1 or Dose 2 button to start the registration.
Dose 1 Dose 2
The coffee product is extracted.
When the desired volume is reached, pressed again on the coffee button to stop the extraction.
The programmed value is memorized.
The programmed button lights Off.
The Button n°3 keeps blinking.
Do the same with the 2
nd
button.
To escape from the “programming doses” mode:
Press on B3 Button.
Or wait for 30 seconds.
To Next Page
Loading...
