Conti MONTE-CARLO - Page 44

MONTE-CARLO - 11/2015 - SOFT V 2.11 44
 BIENNAL MAINTENANCE:
- A kit n° 450201, for the following operation is available for sale.
- Change the pump inlet filter (No. 411861)
- On the steam boiler:
o Change vaccum valve (No. 408898)
o Change the safety valve (No. 411827)
o Dismantle and clean the injectors
- On the coffee boiler:
o Change the limiter 12 Bars (No. 409774)
o Change the draining valve (No. 430046)
- On the inlet bloc valves:
o Change the filter (No. 470199)
o Replace the gasket (No. 219000) of 2 non-return valves
o Change the limiter 12 Bars (No. 409774)
o Change the inlet boiler valve (No. 470161) + 2 PTFE gasket (No. 407500)
- On the cold water valve block :
o Change cold water valve (No. 466273)
- On the pre-brewing valve :
o Change the pre-brewing valve (No. 450033)
- On the coffee groups
o Remove all the parts and uncork all the holes in the group head.
o Change the O-ring nozzle (No. 403457)
o Change the filter nozzle (No. 403458)
o Change the solenoid coffee (No. 4072391) + 2 PTFE gasket (No. 407500)
- On the 2 electrical taps
o Change the solenoid "hot water" (No. 470161)
o Change the 2 PTFE gasket (No. 407500)
o Change the O-ring of the adjusting screw (No. 400 039)
- On the 2 steam taps:
o Change the 2 O-rings (No. 403457)
o Change the 1 gasket (No. 407502)
o Change the O-ring (No. 356500)
- On the 2 "steam" output and on the 2 "hot water" output
o Change the O-ring (No. 061200)
o Change the O-ring (No. 055300)
o Change the washer (No. 401320)
o Change the O-ring of steam nozzles (No. 055400)
- On the flowmeter :
o Change the non-return valve (No. 415167)
- Change the silicone tubes evacuation 3-way valves cafes (No. 405621)
- For water quality issues, it is recommended to fully drain the boiler.