Conti MONTE-CARLO - 4 INSTALLATION; 4.2 Protections; 4.3 Water supply; 4.4 Drain

MONTE-CARLO - 11/2015 - SOFT V 2.11 5
4 INSTALLATION
4.1 Standby In case of a standby of the machine (standby = 2 months):
 The first thing to do is to test your machine in a lab.
 If the machine stops running for a long time, you could have sediment in some places.
 More precisely in small area like the spray nozzle.
4.2 Protections
 It is necessary to place before the machine:
o A water shut off valve.
o An electrical protection standard, suitable for voltage and power consumption.
4.3 Water supply
 Recommended operating pressure from 1.5 MPa to 6 MPa
 Water connection pin 3/8"
 The water supply pipes must resist to 145 Psi / 10 MPa
4.4 Drain
 Without pressure.
 A tip on the outlet of the machine and a pipe is supplied with the machine
 Ensure a connection that causes no risk of fluid return, and ensure good drainage:
 The drain pipe must be located lower than the machine.
 Do not create a bend in the exhaust tube.
4.5 Supplying voltage
 To be specify when ordering : 230V – 50/60Hz Monofase
 Or : 400V – 50/60Hz Trifase