Continental Fireplaces BCDV36CFNTR User Manual (English)

Other manuals for Continental Fireplaces BCDV36CFNTR

Installation And Operating Instructions68 pages

Questions and Answers:

S
Spencer LloydAug 11, 2025
How to adjust flame size on my Continental Fireplaces Indoor Fireplace?
- J
  Jose FarmerAug 11, 2025
  If the flames on your Continental Fireplaces Indoor Fireplace are consistently too large or too small, consider these possible solutions: * If you're out of propane gas, fill the tank. * Check that the manual valve is turned on. * Ensure the spark gap is correct, it should be 0.150” (3.8mm) to 0.175” (4.5mm) from the electrode tip and the pilot burner. * Check the pilot orifice for blockage. * Check pressure readings. If the issue persists, you may need to call the gas distributor or replace the valve.
R
Ruben KentAug 16, 2025
Why does the main burner go out but the pilot stays on in my Continental Fireplaces BCDV36CFNTR Indoor Fireplace?
- T
  Todd SchmidtAug 16, 2025
  If the main burner goes out while the pilot stays on in your Continental Fireplaces Indoor Fireplace, it could be due to a few reasons. The pilot flame might not be large enough or not engulfing the thermopile, so turn up the pilot flame. Alternatively, the thermopile could be shorting, so clean the thermopile connection to the valve and reconnect it. You may also need to replace the pilot assembly.
S
Stuart LopezAug 20, 2025
How to fix a pilot light that won't light on my Continental Fireplaces BCDV36CFNTR Indoor Fireplace?
- N
  Nicole KellyAug 20, 2025
  If the pilot light on your Continental Fireplaces Indoor Fireplace won't light, start by checking if there's a spark at the pilot burner; see if the pilot can be lit by a match. Also check that the wire is connected to the push button igniter and if the push button igniter needs tightening. If the wire insulation is broken or frayed, replace the wire. If the ceramic insulator is cracked or broken, replace the electrode. If these steps don't resolve the issue, replace the push button ignitor.
C
Carlos CollinsAug 27, 2025
Why are the flames too aggressive on my Continental Fireplaces Indoor Fireplace?
- C
  Corey HensleyAug 27, 2025
  If the flames on your Continental Fireplaces Indoor Fireplace are very aggressive, it could be because the door is ajar; ensure the mechanical means of securing the door is providing a tight seal. Another possibility is that the venting action is too great; check to ensure venting is properly sealed.