Controls C3-100-AS User Manual

CONTROLS, INCORPORATED
C O N T R O L S Y S T E M S & S O L U T I O N S
- 5 -
SLEEP MODE
To minimize current draw, the panel goes into a sleep mode two minutes after being set in auto
mode. In sleep mode, the display goes blank and the red lamp blinks once every ten seconds. The
engine ECU is also turned off.
Upon receiving a signal from a float or transducer the panel wakes up, the display turns back on and
normal operation commences.
Pushing any of the four buttons wakes up the panel and turns the display on. It will return to sleep
mode after a two minute period.
For service purposes, to keep engine ECU powered, access the menu system. The engine ECU
remains on when the menu system is active.
Red Lamp

Controls C3-100-AS Specifications

General

Brand	Controls
Model	C3-100-AS
Category	Controller
Language	English