CONTROLS, INCORPORATED
C O N T R O L S Y S T E M S & S O L U T I O N S
- 12 -
SERVICE/MAINTENANCE MESSAGES
Maintenance intervals and messages can be enabled.
Maintenance Intervals can be turned on allowing predetermined time intervals to be monitored for
approaching and past service conditions. Because new engines typically require a shorter interval to
the first required service, the controller has two sets of programmable intervals. The first service
warning is set for 75 hours and the first service required alarm is set for 100 hours.
Once the initial service time has been reset using the control panel maintenance menu, the service
intervals will automatically be incremented to the Next Service Warning Interval and the Next Service
Required Interval as programmed into the controller.
After resetting the interval, the controller will automatically add the engine hours and the interval time
to show the operator exactly when service will be required next. The control panel will display a yellow
LED lamp and a message as the service intervals expire and maintenance is required. Expired service
intervals will not stop the engine from running.
Maintenance Configuration Menu
Service Interval Message On/Off
Service Warning Hour Selection
Service Required Message Hour Selection
Next Service Warning Interval Selection
Next Required Message Hour Interval Selection
1st Warning Service Hour Selection
1st Service Required Message Hour Selection
To Next Page
Loading...
Need help?
General
