12
Vehicle Installation
Using LATCH Top Tether Strap
If your vehicle is equipped with LATCH Top
Tether Anchor points, you can use the Top
Tether Strap to attach the Head Support.
NOTE:
All vehicles manufactured since September 1,
2002 are equipped with tether anchors located
behind the rear seats.
1. Consult your vehicle owner’s manual to
locate the tether anchor points.
2. Pull and fully extend the top tether strap.
3. Locate the hook on the strap and loosely
attach the tether strap to the anchor
point.
4. Pull the tether strap to remove ALL slack
(Fig. A and B).
5. Make sure the tether strap is taut and
that the child seat is properly secured.
Fig. A (Car)
Fig. B (Van)
NOTE:
The Carrot 3 is secure when it cannot be moved front-to-back or side-to-side
more than 1 inch (2.5 cm) at the belt path. If the Carrot 3 is not secure, repeat
the installation process or use an alternate seating location.
To Next Page
Loading...
