Flash XDR User’s Manual
File Naming Convention
The video/audio file naming convention is shown below. The file name follows an 8.3 format, where 8
characters identify the file name and 3 characters the extension (.mov or .mxf)
1) Unit ID Number: Unit ID is assigned under the System Menu, and is used to identify
multiple Flash XDR units if needed. The default is 01.
2) Clip Number: The clip number is incremented every time a recording is started. If the Unit
ID number is incremented, the clip number resets to 001.
3) File Number: File number is incremented whenever the file being recorded for a particular
clip reaches the max file size (~3.5GB). It is reset to 001 if the clip number or Unit ID is
incremented. During a record, the clip number and Unit ID will remain constant as the file
number increments. This will go across several card slots if the record time is long enough.
4) File Name Extension: the possible extensions are .mov (Quicktime) or .mxf (MXF files). In
general Quicktime files are used on the Mac and MXF files on the Pc.
Convergent Design, Inc 19
To Next Page
Loading...
Need help?
General