Copower SANDOLAB TP - Page 34

34
3-04
Preliminary Count Value
d0 to d999
d0
3-05
Multi-Function Output1 (Photo-
coupler Output)
d0: Not Used
d1: AC Drive Operational
d2: Max. Output Freq. Attained
d3: Zero Speed
d4: Over Torque
d5: Base-Block (B.B.)
d6: Low Voltage Detection
d7: AC Drive Operation Mode
d8: Fault Indication
d9: Desired Freq. Attained
d10: PLC Program Running
d11: PLC Program Step Complete
d12: PLC Program Complete
d13: PLC Program Operation Pause
d14: Terminal Count Value Attained
d15: Preliminary Count Value Attained
d16: Ready State Indicator
d17: FWD command indication
d18: REV command indication
d1
3-06
Multi-Function Output2 (Relay
Output)
d8
d1
Group 4 Input Function Parameters
4-00
Potentiometer Bias Frequency @
d 0.0 to d 100.0%
d0.0
d20
4-01
Potentiometer Bias Polarity @
d0: Positive Bias
d1: Negative Bias
d0
4-02
Potentiometer Frequency Gain
@
d1 to d200 %
d100
d84
4-03
Potentiometer Reverse Motion
Enable
d0: Forward Motion Only
d1: Reverse Motion enabled
d0
4-04
Multi-Function Input Terminal 1
(M0, M1)
d0: Parameter Disable
d1: FWD/STOP, REV/STOP
d2: FWD/REV, RUN/STOP
d3: 3-wire Operation Control Mode
d4: E.F. External Fault Input (N.O.)
d5: E.F. External Fault Input (N.C.)
d6: Reset
d7: Multi-Step Speed Command 1
d8: Multi-Step Speed Command 2
d9: Multi-Step Speed Command 3
d10: Jog Operation
d11: Acceleration/deceleration Speed
d1
d2
4-05
Multi-Function Input Terminal 2
(M2)
d6
4-06
Multi-Function Input Terminal 3
(M3)
d7
4-07
Multi-Function Input Terminal 4
(M4)
d8
4-08
Multi-Function Input Terminal 5
(M5)
d9