Copystar CS 181 - Page 263

2KJ/2KH
2-4-3
Section
Maintenance
part/location
Method
Maintenance
cycle
Points and cautions Page
Optical
section
Slit glass Clean Every service Clean with a dry cloth (do not
clean with a wet cloth or alcohol).
Contact glass
Clean Every service Clean with alcohol and then a dry
cloth.
Mirror 1 Clean User call Clean with a wet cloth and then a
dry cloth only if vertical black lines
appear on the print image.
Mirror 2 and mirror 3 Clean User call Clean with a wet cloth and then a
dry cloth only if vertical black lines
appear on the print image.
Lens Clean User call Clean with a dry cloth only if verti-
cal black lines appear on the print
image.
Reflector Clean User call Clean with a dry cloth only if verti-
cal black lines appear on the print
image.
Exposure lamp Check or
replace
User call Replace if an image problem
occurs or after the exposure lamp
does not turn on.
P.1-5-24
Optical rail Check or
grease
User call Check noise and shifting and then
apply optical rail grease EM-50LP.
Original size detection
sensor
Check or
clean
User call Clean the sensor emitter and sen-
sor receiver with alcohol or a dry
cloth only if there is a problem.
Laser scanner unit Check or
clean
User call Clean the slit glass with alcohol
and then a dry cloth.
P.1-5-35
Section
Maintenance
part/location
Method
Maintenance
cycle
Points and cautions Page
Transfer/
separation
section
Transfer roller Clean User call Vacuum or clean with a dry cloth
when user call occurs.
P.1-5-45
Separation electrode Check or
clean
User call Clean with a cleaning brush.
Section
Maintenance
part/location
Method
Maintenance
cycle
Points and cautions Page
Developing
section
Developing unit Check or
replace
User call Replace if the problem occurs. P.1-5-44
Section
Maintenance
part/location
Method
Maintenance
cycle
Points and cautions Page
Drum section Main charger unit Check or
replace
Every service Replace if an image problem
occurs.
P.1-5-43