- 13 -
¾ If you have chosen to create a new partition/image, you should see the following screen
after you submit your selection.
Please refer to the “Input Name and Number” section of “Chapter 2: Getting to know
your System” to enter the desired title. Then press the “ENT”/Enter to continue to the
next step.
After you submitted a hard drive partition/image name, the system will
automatically append a partition/image name suffix of .VEF.
¾ If you have chosen to overwrite one of the existing partitions/images, you should see the
following screen after you submit your selection.
Then press “ENT”/Enter to continue to the next step.
¾ If you have chosen Auto Generate, Then precede to the next step.
Step5: Please place your master disc into the Reader or the 1
st
Writer if there’s no Reader
installed in your system. Once the system recognizes your master disc, the loading progress
screen will be displayed, as show below:
Step6: Once the loading process is completed, you should see the following screen:
4012MBindicatesthetotalcapacityofyour
masterdisc.
FUN1.VEFindicatesthenameofthe
partition/imagewherethedataisbeingloaded
into.
10%indicatesthecurrentpercentageofthe
masterdiscthathasbeenloadedintothehard
drive.
401MBindicatesthecurrentamountdatafrom
themasterdiscthathasbeenloadedintothe
harddrive.
Edit Partition Name
[ ]OK?
This Will Overwrite
[FUN1.VEF ]OK?
Loading... 4012MB
FUN1.VEF 10% 401MB
Load Partition OK!
Press OK to Continue
To Next Page
Loading...